Can be used in grouting of ceramics, tiles and similar coating materials wider than 6mm.
• Areas effected by high pressure (>(>100 Bar),)and does not apply to hygiene, exposed to chemicals.
• Swimming pools,
• Deformable areas such as floor heated tiles.
• It can be used up to an hour.
• Fully hardening duration is 12 hours
• Area can be open for traffic after 24 - 48 hours.
• Environment temperature: between +5 °C and +35 °C
• It should not be applied to surfaces that under frost hazard within 24 hours, frozen and melting
• It should not be applied in strong winds, areas that under direct sunlight or hot surfaces.
• For homogeneous drying, joint gaps should be excavated via thin stick and it should be cleaned with a brush from dust, sawdust and such as cement debris.Joint gaps should be humidified before application specifically on walls.
•Approximately 5.6-6.6 liters of water and 20 kg of Fenix Grout should be mixed thoroughly, preferably with a low-speed mixer or trowel so that there are no lumps.
• After 10 minutes of resting, Fenix Grout should be mixed again for 1-2 minutes before use.
• Mortar should be applied on joint gaps with rubber tipped mop or joint spreading trowel with hard rubber base
• In order to fill the gaps properly, it should be drawn first parallel and then diagonally.
• The excess of the mortar on the surface should be scraped off with a soft-tipped spatula or dampened sponge-tipped spatula, waited for 15-30 minutes depending on the environment temperature, then wiped with a damp sponge, and the thin joint layer that may remain on the surface should be thoroughly cleaned.
•In order to be highly aged, the application area should be revised daily.
• All tools used after the application should be washed with water before drying.
• Soaking the ceramics in water before application should be avoided, as it may cause yellowing in white and light-colored joint fillers.
