It is used for the last coating material on all outdoors and outdoor heath insulation systems.
Outdoors;
• Cement based plaster,
• Exposed Concrete (Fenix Thick Repair Mortar or Fenix Exposed Concrete Primer Applied)
• Gas concrete (Gas concrete plaster applied)
• Mixing duration: 5 minutes
• Resting duration for mortar: 5 minutes
• Prepared mortar can be used for 3-4 hours
• Application thickness: 2 mm
• Surface needs to be dry, clean, and durable.
• Surface should be humid before application, must be wet enough under hot and windy weather
Yatay ve 45 derecenin altında eğimli yüzeylerde uygulanmaz.
Direkt tuğla ve gazbeton üzerine ve zayıf sıvalı yüzeylerde uygulanmaz.
• Surface and Environment temperature: between +5 °C and +30 °C
• It should not be applied under hot weather conditions, areas that under direct sunlight or hot surfaces.
• It should not be applied to surfaces that under frost hazard within 24 hours, frozen and melting.
It should be according to recommended water rate, mixing and resting durations while preparing the mortar.
Mildly hardened materials that prepared before should not be added to the new mixture.
It should be avoided to applying under direct sunlight.
DDark colors should not be preferred in applications to be made on exterior thermal insulation systems.
. Brightness reference value should not be bigger than 25 of the chosen color. Dark colors can be used as decoration if its not more than %10 of exterior.
All used tools should be washed with water before they get dry after the application.
It must not be left as if it’s the last layer. After the surface dries up, it should be painted with silicon based exterior paint.
It should be waited for at least 7 days before painting.
Approximately 6-6,5 liters of water and 25 kg of Fenix Decorative Plaster should be mixed thoroughly, preferably with a low-speed mixer or trowel so that there are no lumps
Prepared mortar should be rested for 5 minutes and be mixed again before use.
It should be laid evenly on the surface with a stainless steel trowel. Application thickness should be adjusted according to the largest pattern stone.
Patterning should be done in circular shapes with a plastic trowel. Patterning always should be done while Fenix Decorative Plaster is still wet.
Identified durations are valid in 20 °C floor or environment temperatures, in low temperatures duration will be longer, in high temperatures duration will be shorter.
Dekan Boya ve Yapı Kimyasalları San.Tic.Ltd.Şti. is not responsible for application errors that may occur if the product is used for purposes other than its intended use or if the application conditions and recommendations mentioned above are not followed.
